Vista Ademco -10SE Guide de dépannage télécharger pdf (Page 99)

●

—

When one button of a transmitter (RF, UR, or BR) is activated, all

zonesassignedto other buttons on that transmitter are cleared.This

also appliesto 5816 and 5817 transmitters which have multiple loops

(zones).

Any tmmsmitterthat is not “learned”will not turn offits zonenumber.

Exit this modeby keying Installer code+ OFF.

b. GWNO GO TEST MODE: By pressingInstaller code+ # +4, a mode

similar to the user test mode (code+ TEST) is entered, but the wireless

receiver gain is reduced. Checking in this mode assists in determining

goodmounting locationsfor the transmitterswhen the systemis being in-

stalled and verifiesthat the RF transmission has Sufficientsignal ampli-

tude margin for the installed system.

Exit the modeby enteringInstaller code+ OFF.

NOTE:

THE TEST MODE WILL BE AUTOMATICALLY TERMINATED

AFTER 4 HOURS IF THE INSTALLER OR USER DOES NOT

MANUALLY TERMINATE IT.

This insures that Fire and Panic zoneswill not remain disabled.

TO THE INSTALLER

Regular

maintenance and inspection(at leastannually) by the instd.ler and frequent testing

by the user are vital to continuoussatisfactoryoperationof any alarm system.

The installer should assume the responsibility of developing and offering a regular

maintenance program to the user as well as acquainting the user with the proper operation

and limitations of the alarm system and its component parts. Recommendations must be

included for a specificprogram of fiwquenttesting (at least weekly) to insure the system’s

proper operation at all times.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 119 120

Pas de commentaire

Vista Ademco -10SE Guide de dépannage Page 99