Vista Ademco -10SE Guide de dépannage télécharger pdf (Page 18)

3. Connectremote Keypadsfor Partition 1 to brminals 4,5,6, and 7 on the

controlboard, as shownin Figure 6.

4. Connect remote Keypads for Partition 2 @ the 4-pin connector on the

control board (see the SurnmarY of Connections diagram for location of

the 4pin connectorfor partition-2).

CON?-ROL

TERMINALS

KEYPADCONNECTOR CABLE(SUPPLIEDWITH VISTA-20)

N4632-E

PARTITION 2 KEYPADS

CONNECTOF?PINS FOR

PARTITION2 ON CONTROL BOARD

Fii6. Kaypad Commctm

“ naTo The Control Board

Mountimg the Kaypads

1. Make sure addressable type keypads

(4137AD, 5137AD, 6128,6137,

6138, and 6139) are set to non-addressablemode (address 31), which is

the factory default setting. Refer to the instructions provided with the

keypad for addresssettingprocedure.

2. Mount the keypads at a height that is convenientfor the user. Refer to

the instructionsprovidedwith the keypadfor mounting procedure.

You can either surface mount or flush mount keypads (using an

appropriate Trim Ring Kit: 5137TRK or 6139TRIQ. Refer to the

mounting instructions and template included with the keypad and/or

trim ring kit for spetic information.

Wing a Supplementary Power supply to Powar Add&mid Kaypada

The conixolprovides 600mA for powering keypads (up to a maximum of 4 per

partition) end other devicesfkom the auxiliary power output. The backup

batterywill supply powerto thesekeypadsin the event that AC power is lost.

When the control’sauxilky powerload for all devicesexceeds600 @ you

can power additional keypads fkom a regulate~ 12VDC power supply (e.g.,

487-12 supplies 12V, 2504, 488-12 supplies 12V, 5001nA). Use a UL

Listed,battery-backedsupply for UL installations.

The 487-12/488-12 power supplieshave a backup battery which can power

thesekeypads in the event ofAC powerloss.

-18-

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 119 120

Pas de commentaire

Vista Ademco -10SE Guide de dépannage Page 18