Vista Ademco -10SE Guide de dépannage télécharger pdf (Page 84)

–84–

• When one button of a transmitter (RF, UR, or BR) is activated, all zones

assigned to other buttons on that transmitter are cleared. This also applies

to 5816 and 5817 transmitters which have multiple loops (zones).

• Any transmitter that is not “enrolled” will not turn off its zone number.

Exit this mode by keying Installer code + OFF.

b. GO/NO GO TEST MODE: By pressing Installer code + # + 4 on partition

1's keypad, a mode similar to the user test mode (code + TEST) is entered,

but the wireless receiver gain is reduced. Checking in this mode assists in

determining good mounting locations for the transmitters when the system is

being installed and verifies that the RF transmission has sufficient signal

amplitude margin for the installed system.

Exit the mode by entering Installer code + OFF.

NOTE: System Test Mode (code + test) will be automatically terminated after

4 hours if the installer or user does not manually terminate it.

This insures that Fire and Panic zones will not remain disabled.

However, Sniffer Mode (installer code + # + 3) does not automatically expire.

You must manually exit (installer code + OFF) sniffer mode to return to normal

operation. Sniffer Mode also terminates if a user arms the system.

TO THE INSTALLER

Regular maintenance and inspection (at least annually) by the installer and frequent testing by the

user are vital to continuous satisfactory operation of any alarm system.

The installer should assume the responsibility of developing and offering a regular maintenance

program to the user as well as acquainting the user with the proper operation and limitations of

the alarm system and its component parts. Recommendations must be included for a specific

program of frequent testing (at least weekly) to insure the system's proper operation at all times.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 99 100

Pas de commentaire

Vista Ademco -10SE Guide de dépannage Page 84